Special contactor requirements for in-process test of stacked dies
high compliance probes to accommodate for deflections
optimally balanced contacting force to ensure best yield at high-parallel testing without damaging sensitive, non-packaged dies
Special contactor requirements for final test of POPs and TSV packages
high pin count to cope with high number of I/Os
well managed contacting force
double sided contacting
combined feature such as RF, Kelvin, High Power,etc.
In-Process Test of Stacked Dies in Assembly
In-process test is a new approach to ensure best assembly yield of 3D packages. (read more about 3D in-process test here: http://multitest.com/3dintegration/ ). The challenge at in-process test is that the contactors need to touch stacked, bare dies. A stack of dies may even be more sensitive than a single die at wafer probing. However, a certain force is required to ensure reliable contacting and satisfactory yield. The contacting force needs to be well balanced to be soft and gentle enough but at the same time high enough.
The Multitest in-process test setup leverage high-parallel test on the InStrip3D that requires high compliance from the probes to accommodate for deflection.
In-Process Test of PoPb before final Assembly to PoP
Package components for highly integrated PoPs have pads/balls on the top and the bottom. Double-sided contacting is required. The handler needs to support this accordingly.
Final Test of PoPs or TSV Packages
3D packages consist of homogenous but also heterogeneous components. Contactors need to be able to support each functionality. A modular contactor design is required to optimize cost-effectiveness and performance. Multitest can combine various probes and pins from the Quad Tech™ and Blue Line™ family to provide an optimum ideal set-up.
Finally, highly integrated packages have a high number of I/Os and high density. Contactors need to provide fine pitch capabilities but also ensure best yield with minimum contacting force. This is ideally featured by the Multitest Quad Tech™ design.
We won´t track your info when you visit our site. But in order to comply with your preferences, we´ll have to use just one tiny cookie so that you´re not asked to make this choice again.AcceptRead more